DARK stamping plate 15

DARK PLATE - metal plate for creating designs using the "stamping" technique. It features deep and clear patterns for comfortable work. The wide selection of designs allows for quick and easy creation of any pattern. DESCRIPTION - features high-quality engraving for easy work; - allows for even complex designs without drawing skills; - recommended to use together with DARK STAMPING POLISH and DARK Stamping Tool. USAGE INSTRUCTIONS 1. Perform a manicure and apply base/gell or color, cure in the lamp; 2. If there is a sticky layer - remove the sticky layer using DARK GEL CLEANSER; 3. Apply polish on the plate, scrape off the excess and transfer the pattern to the stamp; 4. Transfer the pattern from the stamp to the nail with a rolling or flattening motion; 5. Top coat (if the top coat runs off the design - apply a thin layer of clear base, and then the top coat). WHY THE PATTERN MAY NOT TRANSFER TO THE STAMP 1. The polish must not be thickened, take enough polish with the brush to distribute it over the pattern; 2. The polish should be applied on the plate in 1-2 movements, the longer you apply it - the higher the chances that the transfer will be worse, because the polish dries in the air; 3. Work with the scraper at about a 45-degree angle, while not pressing too hard to avoid "squeezing" the polish out of the pattern; 4. Work quickly with the scraper (2-4 movements are enough), and avoid sweeping across the whole plate; 5. Next, quickly place the scraper down and take the stamp in hand (remember, we don’t have extra time when working with polishes); 6. Transfer the pattern to the stamp with a gentle rolling motion, DO NOT try to PRESS the stamp into the plate, the harder you press - the more polish will remain on the plate.