DARK 10 stamping plate

Description 

DARK PLATE - a metal plate for creating nail designs using the 'stamping' technique. Features deep and precise engravings for convenient work. A wide selection of designs allows you to quickly and easily make any pattern.

DESCRIPTION

• features high-quality engraving for ease of use;
• enables even complex designs without drawing skills;
• recommended to use with DARK STAMPING POLISH and DARK Stamp for stamping.

HOW TO USE

1. Perform a manicure and apply base/gel or color, cure under a lamp;
2. If a sticky residue remains, remove it using DARK GEL CLEANSER;
3. Apply polish to the plate, use a scraper to remove excess, and transfer the design to the stamp;
4. Transfer the design from the stamp to the nail with a rolling or straightforward movement;
5. Seal with top coat (if the top coat slips off the design, apply a thin layer of transparent base first, then the top coat).

REASONS WHY THE DESIGN MAY NOT TRANSFER TO THE STAMP

1. The polish should not be too thick; load enough polish on the brush to cover the design evenly;
2. Apply polish to the plate in 1-2 strokes; the longer it takes, the more likely it is to dry on the plate, making transfer difficult;
3. Use the scraper at about a 45-degree angle without applying excess pressure to avoid removing too much polish from the engraving;
4. Scrape quickly (2-4 strokes are enough), without sweeping over the entire plate;
5. Immediately set aside the scraper and take the stamp in your hands (timing is critical when working with polishes);
6. Transfer the design onto the stamp with a gentle rolling motion; do NOT press the stamp hard into the plate, as excessive pressure leaves more polish behind.