Stamping plate DARK 03

DARK PLATE - a metal plate for creating designs in the stamping technique. It has deep and clear patterns for convenient work. A wide selection of designs allows you to quickly and easily make any pattern. DESCRIPTION - have quality engraving for convenient work; - allow for even complex designs without drawing skills; - recommended to use together with DARK STAMPING POLISH and DARK Stamping Tool. APPLICATION METHOD 1. Perform a manicure and apply base/gell or color, dry in the lamp; 2. If there is a sticky layer present - remove the sticky layer using DARK GEL CLEANSER; 3. Apply polish to the plate, use a scraper to remove excess and transfer the pattern to the stamper; 4. Transfer the pattern from the stamper to the nail with a rolling or flat motion; 5. Cover with top coat (if the top coat runs off the pattern - apply a thin layer of clear base first, and then the top coat). WHY THE PATTERN MAY NOT TRANSFER TO THE STAMP 1. The polish should not be thickened, you need to take enough polish on the brush to distribute it over the pattern; 2. Apply polish to the plate with 1-2 strokes, the longer you apply, the greater the chances that the transfer will be worse because the polish dries in the air; 3. Work with the scraper at an angle of about 45 degrees, while not pressing too hard to avoid 'squeezing' the polish out of the pattern; 4. Work quickly with the scraper (2-4 strokes are enough), without sweeping across the entire plate; 5. Then quickly set down the scraper and take the stamper in your hand (remember that we have no extra time when working with polishes); 6. Transfer the pattern to the stamper with a gentle rolling motion, DO NOT try to PRESS the stamper hard into the plate, the more you press, the more polish will remain in the plate.